To Next Page

To Previous Page

Preparation

Removing the insulating strip

Remove the insulating plastic strip from the battery if the

battery is being used for the rst time. It is located at the

bottom back side of the remote control.

Battery Replacement for the Remote Control

The remote control requires a CR2032, 3V Lithium battery.

1. Slide and hold the battery release tab in the direction

of the arrow and at the same time pull out the battery

holder.

2. Fully pull out the battery holder and remove the old

battery.

3. Replace with a new battery.

4. Insert the battery holder back into the remote

control.

Handling the Battery

• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause re,

personal injury or damage to property.

• Install the battery correctly by following the polarity (+ and –) indications in the battery compartment.

• When the battery is exhausted, the remote control will not function.

• Only use the battery type indicated in this manual.

• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with the local

regulations.

• Small button cell batteries such as the one used in the remote control are easily swallowed by young

children and this is dangerous. Keep loose button cells away from young children and make sure that

the battery holder tray is secure in the remote control. Seek medical advice if you believe a cell has

been swallowed.

Handling the Remote Control

• Do not drop the remote control.

• Do not allow anything to impact the remote control.

• Do not spill water or any liquid on the remote control.

• Do not place the remote control on a wet object.

• Do not place the remote control under direct sunlight or near sources of excessive heat.

• Remove the battery from the remote control when not in use for a long period of time, as corrosion or

battery leakage may occur and result in physical injury, and / or property damage, and / or re.

• When the battery is exhausted, the remote control will not function.

RD-D90_IB.indd 10 06/06/2016 09:18

JVC RD-D90 User Manual

Questions and Answers: