Relerences
• HandlingDiscs
• Remove tile disc from its case by holding it at
the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or
To clean the disc
Wipe the disc with a soft cloth in a straight line
from center to edge.
• DO NOT use any solvent -- such as
conventional record cleaner, spray,
thinner or benzine -- to clean the disc.
• Cleaning the system
bend the disc.
• Put the disc back in its case alter use to
prevent warping.
• Be careful not to scratch the surface of the
disc when placing it back in its case.
• Avoid exposure to direct sunlight, temperature
extremes and nloisture.
Stains on the system should be wiped off with a soft cloth. If the
system is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with a
dry cloth.
Since the system may deteriorate in quality, become damaged or
get its paint peeled oft'. be careful about the following.
• DO NOT wipe it with a hard cloth.
• DO NOT wipe it strong.
• DO NOT wipe it with thinner or benzine.
• DO NOT apply any volatile substance such as insecticides to it.
• DO NOT allow any rubber or plastic to remain in contact with
it I_r a long time.
PROBLEM POSSIBLE CAUSE SOLUTION
Power does not come The power cord and/or system cord is not connected. Connect the power cord and system cord correctly.
on. (: -" pg. 15)
The remote control does The batteries are exhausted. Replace the batteries. (_ -" pg. 7)
not work. Sunlight is falling directly on the remote sensor. Hide the remote sensor from direct sunlight.
No sound. The system cord and/or speaker cord is not connected. Check the connection. (-" pg. 15)
The audio cord is not connected to AUDIO IN (VCR) Connect the cord correctly. (-" pg. 15)
and/or DIGITAL IN (DBS) correctly.
An incorrect source has been selected. Select the correct source. ( " pg. 19)
The decode mode is not set correctly. Select the proper decode mode. (-" pg. 37)
No picture is displayed The video cord is not connected correctly. Connect the cord correctly. (_-" pg. 14)
on the TV screen. The disc is not playable. Use a playable disc. (-" pg. 3)
No picture is displayed The scan mode is set to "PROGRESSIVE" though the Change the scan mode to "INTERLACE". (-" pg. 20)
on the TV screen, the center unit is connected to the TV which does not
picture is blurred, or the support the progressive video input such as a
picture is divided into conventional TV.
two parts.
Video and audio are The disc is scratched or dirty. Replace or clean the disc.
distorted. A VCR is connected between the center unit and the Connect the center unit and TV directly. (_-" pg. 14)
TV.
The picture does not fit The monitor type is not set correctly. Set "MONITOR TYPE" properly. (-" pg. 39)
the TV screen.
Hard to listen to Antennas are disconnected. Reconnect the antennas correctly and securely.
broadcast because of (: -"pg. 8)
noise.
45
To Next Page
Loading...
Need help?
General
