KEB COMBIVERT F4-S/1.2 - Parameter Structure; Parameter Groups and Parameter Numbers

Parameter Structure
11
ANTRIEBSTECHNIK
3 Parameter Structure
Each parameter is divided into 3 groups:
1. Parameter number
2. Parameter group
3. Parameter set (only with programmable parameters)
The parameter numbers distinguish between each parameter in a group. Parameter
groups are combined according to their functions. This means all parameters needed
to set a function are found in a parameter group. Combivert F4-S has the following
parameter groups.
Run(ru) - Parameter
Contains all operating displays, i.e. all values
that change during operation, without changing
the parameter.
Operational(oP) - Parameter
All parameters for the setpoint input, limitation,
ramp presetting etc.
Protection(Pn) - Parameter
All protective functions (e.g. LA-Stop) and all
Keep-on-runnig functions (e.g. Auto Restart).
(uF) - Parameter
Setting of volt/hertz-characteristic as well as the
modulation parameter (e.g. switching
frequency).
Drive(dr) - Parameter
All motor specific parameters.
Control(cn) - Parameter
Control parameters for speed and torque
User-definition(ud) - Parameter
All parameters for individual setting of the
operating surface and the serial interface.
Free-prog.(Fr) - Parameter
Programs and activates parameter sets.
Analog-I/O(An) - Parameter
Programs the analog in-/outputs
Digital-In(di) - Parameter
Programs the digital inputs.
Digital-Out(do) - Parameter
Programs the digital outputs.
Level(LE) - Parameter
Switching conditions for the digital outputs.
Information(In) - Parameter
Information about inverter type, serial no. and
diagnostic parameter like error counter, Quality
Assurance number.
Parameter Groups
and Parameter
Numbers