KEB COMBIVERT F5 Series User Manual

Device size 24 26 27 28 29
Housing size U U U P P
Cooling mode (L=air; W=water) L L W L W L W
Number of modules for master/slave – – – – – –
Input data
Mains phases 3
Permitted mains forms TN system
Rated input voltage U
N / V 400
Input voltage range U
in / V 340…480 ± 0%
Mains frequency f
N / Hz 50 / 60 ± 2
Rated input power S
N / kVA 125 173 208 256 319
Rated input current I
N / A 180 250 300
1)
370 460
Max. permissible mains fuse type gR / aR 250 350 400 500 630
Output data
Rated output voltage U
outN_dc / V 680
Output voltage range
2)
U_dc / V 530…840
Overvoltageswitch-o󰀨(E.OP) U
OP_dc / V 840
Power supply/regenerative rated current
3)
IoutN_dc / A 180 250 300
4)
370 460
Max. regenerative DC current 30 s I
out_max_dc / A 270 313 375 462 575
Rated switching frequency f
SN / kHz 8 4 8 8 4
5)
4
5)
Max. switching frequency fS_max / kHz 8 8 8 8 4 4
Other data (referring to the rated data)
Overcurrentcut-o󰀨(E.OC) I
OC / % 180 150 150 150 150
Overload current (E.OL) 30 s I
OL / % 150 125 125 125 125
Max. permissible DC link capacity C
ext / mF 45 43 40 35 35
Max. AIC charging current (=> 6.5) I
AIC / A 226 226 226 98 98
Max. external charging current (=> 6.5) I
ext / A – – – –
Max. permissible total charging current (=> 6.5) Ipre / A 226 226 226 98 98
Mains input circuit (=> 6.5) Type D1 D1
Permissible DC fuses => „DC fuses“
Short-circuit factor at the connection point (S
kn / SN) 15 < Skn“ / < 350
10 < Skn“ /
< 350
Power dissipation at rated operation P
BR / W 2230 2550 3500 4500 3000 3800
Max. heat sink temperature t
_max / °C 90 90 60 90 60 90
6) 7)
90
6)
1)
The input current of the drive converter must be limited to the rated current of the AIC / LCL lter, if
necessary.
2)
The operation is dependent on the voltage setpoint and the UOP limit (=> Programming manual).
3)
Measured at a reference voltage of 680 V DC.
4)
Limited by the rated current of the DC-terminal ! The input current must be limited to 300 A for input
voltages < 400 V.
5)
Must be set to 4 kHz for AIC operation (factory setting 2 kHz) !
6)
Special settings are required for this device sizes (Reduction of the max. heat sink temperature to
85°C, => Programming manual).
7)
Max. ambient temperature Ta of 35°C.
28
UNIT DATA

KEB COMBIVERT F5 Series Specifications

General

Brand	KEB
Model	COMBIVERT F5 Series
Category	DC Drives
Language	English