18
TRANSMITTING
1
Select the desired zone and channel using the selector and
the
Zone
or
CH/GID
keys.
• In Voting, Voting with Signaling, and Free Channel Call zones,
the channel is seleted automatically.
3
In Conventional zones, press the key programmed as
Monitor
or
Squelch Off
to check whether or not the
channel is free.
• If the channel is busy, wait until it becomes free.
4
Press the
PTT
switch and speak into the microphone.
Release the
PTT
switch to receive.
• For best sound quality at the receiving station, hold the
microphone approximately 1.5 inches (3 ~ 4 cm) from your
mouth.
• In Voting and Voting with Signaling zones, the transceiver will
search for the closest repeater and transmit using that repeater’
s frequency.
• In Free Channel Call zones, the transceiver will search for a
free channel and will begin transmitting on that channel.
RECEIVING
1
Select the desired zone and channel using the selector and
the
Zone
or
CH/GID
keys.
• Alternatively, in Conventional zones, you can activate the Scan
function if desired.
• In Voting and Voting with Signaling zones, the transceiver will
automatically search for the strongest signal and receive on
that frequency.
• In Free Channel Call zones, the transceiver will automatically
search for any signal and will receive on that channel.
2
When you hear a caller’s voice, readjust the volume as
necessary.
To Next Page
Loading...
Need help?
General
