27
■
RECEIVING
An alert tone will sound, the transceiver will automatically
enter Selcall Mode, and the calling station’s ID will appear
when a Selcall is received.
To respond to the call, press the
PTT
switch and speak into
the microphone.
■
IDENTIFICATION CODES
An ID code is a combination of a 3-digit Fleet number and
a 4-digit ID number. Each transceiver must have its own
Fleet and ID number.
• Enter a Fleet number (100 ~ 349) to make a group call.
• Enter an ID number (1000 ~ 4999) to make an individual call in
your fleet.
• Enter a Fleet number make a call to all units in the selected
fleet (Interfleet call).
• Select “ALL” Fleet and enter an ID number to make a call to
the selected ID in all fleets (Supervisor call).
• Select “ALL” Fleet and “ALL” ID to make a call to all units
(Broadcast call).
Note:
The ID range may be limited by programming.
STATUS MESSAGE
You can send and receive 2-digit Status messages which may
be decided in your talk group. Messages can contain up to 16
alphanumeric characters. Status messages range from 10 to
99 (80 ~ 99 are reserved for special messages).
A maximum of 15 received messages can be stored in the
Queue memory of your transceiver. These saved messages
can be reviewed after reception. Depending on your dealer
settings, when the Queue memory is full, either the oldest
message will be erased when a new message is received or
the new message will not be stored in the Queue memory. The
icon lights when a message is stored in the Queue memory.
To Next Page
Loading...
Need help?
General
