27
EN
Press the (MENU) button quickly to
quit the menu.
Press the (UP) or (DOWN) but-
tons to scroll through the functions to
modify other parameters.
Press the
(MENU) button for more than 1
second (LONG PRESS) to save the modied
value. The value stops ashing. Alternatively,
press the
(MENU) button QUICKLY to
quit the function without saving.
auto close
ready
BASIC PARAMETERS CT10324
CT10324 OLD CT10224 DESCRIPTION DEFAULT MIN MAX UNIT
1
auto close
TCL
Automatic reclosure time (0 = o) 0 0 900 s
2
photo close
ttr
Reclosing time after transit on PH1
(0 = o)
0 0 30 s
3
react time
SEI
Force on obstacles
0 = Maximum impact force
10 = Minimum impact force
3 0 10
4
open speed
SFO
Motor speed during opening
1 = minimum
2 = low
3 = medium
4 = high
5 = maximum
4 1 5
5
sl-op speed
SSO
Motor speed during opening deceleration phase
1 = minimum
2 = low
3 = medium
4 = high
5 = maximum
1 1 5*
6
close speed
SFC
Motor speed during closing
1 = minimum
2 = low
3 = medium
4 = high
5 = maximum
4 1 5
7
sl-cl speed
SSC
Motor speed during closing deceleration phase
1 = minimum
2 = low
3 = medium
4 = high
5 = maximum
1 1 5*
8
SBS setup
SBS
STEP BY STEP or SBS conguration:
0 = Normal (AP-ST-CH-ST-AP-ST…)
1 = Alternate STOP (AP-ST-CH-AP-ST-CH…)
2 = Alternate (AP-CH-AP-CH…)
3 = Apartment block – timer (set
AUTO CLOSE
≠ 0)
4 = Apartment block with immediate reclosure
0 0 4
9
STOP TWO
ST2
Additional stop/edge input:
0 = disabled
1 = PAR input becomes STOP NO
2 = PAR input becomes STOP NC
3 = PAR input becomes EDGE NC in open
4 = PAR input becomes EDGE 8K2 in open
5 = PAR input becomes EDGE 4K1 in open
Attention: to activate EDGE2 the parameter TYPE
EDGE must be 0 (EDGE1 only when closing)
Attention: EDGE2 is connected as “Opening
Edge” and will be considerated if it is engaged
during opening. It will react with a brief reversal of
the gate to clear the obstacle.
Attention: deactivatin safety with DIP SWITCH
has no eect on this input
0 0 5
To Next Page
Loading...
Need help?
General
