EasyManuals Logo

Kioti DK40 User Manual

Kioti DK40
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
MAINTENANCE 6-21
615O632A
Check to ensure the radiator hoses are
free from damage and are tightened prop-
erly every 200 hours or every 6 months,
whichever comes first.
1. If the hose clamps are loose or water
leaks from hose, tighten clamps
securely.
2. If the radiator hoses are swollen,
hardened, cracked, or otherwise
damaged, you must replace the hose.
It is a good practice to replace the radia-
tor hoses once every two years.
CHECKING RADIATOR HOSE AND
CLAMP
(1) Radiator Hose 1 (2) Radiator Hose 2
615O631A
6. After the new filter is in place , fill the
transmission up with oil to the upper
line of the oil gauge.
7. After running the engine for a few
minutes, stop it and check the oil level
again, add oil to the prescribed level.
8. Make sure that the transmission fluid
doesn’t leak through the seal.
IMPORTANT
To prevent serious damage to the
hydraulic system, use only a
DAEDONG genuine filter.
(1) Gauge (2) Oil Filling Plug
(A) Oil Level is Acceptable Within This Range
615O630A
(1) Oil Filter Cartidge
3. Remove the oil filter.
4. Place a film of clean transmission fluid
of the rubber seal of the new filter.
5. Tighten the filter firmly until it contacts
the mounting surface. Then tighten the
filter, by hand, an additional half turn
only.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kioti DK40 and is the answer not in the manual?

Kioti DK40 Specifications

General IconGeneral
Engine Power40 hp
Hydraulic SystemOpen center
Drive4WD
PTO TypeIndependent
Ground Clearance13.4 inches
3-Point Hitch CategoryCategory I
Height92.5 inches
TransmissionSynchro Shuttle

Related product manuals