5-6 DK35/40/450L
STOPPING THE ENGINE
Reduce engine revolution and apply even
foot pressure on both brake pedals. De-
press the clutch pedal and place main
gear shift lever and PTO switch in neutral.
Lower equipment. Allow engine to idle
for a short time before turning it off. Stop-
ping a hot engine at high speed may cause
internal engine damage.
Set parking brake by pulling the rod.
Turn main switch key counterclockwise
to the “OFF” position to open electric
circuit.
7. Turn the switch key to “Start” position.
8. Please take your hands off from the
key when the engine is starting. It is
automatically turned ON.
9. Operation principle of preheating sys-
tem
If you continue to turn the start
switch more than 8 seconds, the
indicator of preheating plug is
glowing.
WARNING
As starting motor needs a lot of
electric current, please do not use
it more than 10 seconds contin-
uously. If it is not started within
10 seconds, stop doing it more
than 30 seconds, and then repeat
the same operation. If it will not
start at all, please do not restart
before the flywheel stops.
10.Let it run for heating for about 5 min-
utes after taking your foot off from
the clutch pedal.
WARNING
Please do not turn the key to start
position while the engine is
running.
1. First, you place the start switch in
“ON” position, and please wait (about
20 seconds) till the indicator light for
preheating is turned off. Now, you can
start. If the start is not smoothly per-
formed in spite of the try, repeat the
above method.
2. Turn the switch key for start to “Start”
position with your foot stepping on the
clutch pedal.
3. Take your hands off from the key when
the engine is starting. It is automati-
cally turned ON.
4. Let it run with warm-up at idle speed
for about 10 minutes after starting.
HOW TO START IN WINTER
To Next Page
Loading...
Need help?
General
