MAINTENANCE 6-15
615O623B
ADJUSTING CLUTCH PEDAL
Proper clutch
pedal free travel(A)
20 ~ 30 mm
(0.8 ~ 1.2 in.)
on the pedal
1. Stop the engine and remove the key.
2. Slightly depress the clutch pedal and
measure free travel at top of pedal
stroke.
3. If adjustment is needed, loosen the lock
nut, remove the clevis pin and adjust
the rod length within acceptable limits.
4. Retighten the lock nut and split the
cotter pin.
(1) Clutch Rod (2) Clutch Pedal
(A) Clearance
Although checking the fuel pipe connec-
tion is recommended every 100 service
hours, it should be done every 6 months
if operation does not exceed 100 hours
in 6 months.
1. If the tightener band is loose, apply a
slight coat of lubricant onto the threads
and securely tighten it.
2. The fuel pipe is made of rubber and
ages regardless of period of service.
Change the fuel pipe together with the
tightener band every two years and
securely tighten.
3. However, if the fuel pipe and tight-
ener band are found damaged or de-
teriorated earlier than two years, then
change them right off.
4. After the fuel pipe and tightener band
have been changed, bleed the fuel
system.
IMPORTANT
When the fuel pipe is discon-
nected in order to be changed
close both ends of the fuel pipe
with a piece of clean cloth or pa-
per to prevent dust and dirt from
entering. Entrance of dust and
dirt cause malfunction of the fuel
injection pump. In addition, par-
ticular care must be taken not to
admit dust into the fuel pump.
615O624A
ADJUSTING BRAKE PEDAL
(1) Brake Pedal
(A) 25 ~ 35mm (1.0 ~ 1.4 in.)
CAUTION
To avoid personal injury:
Stop the engine and chock the
wheels before checking brake
pedal.
To Next Page
Loading...
Need help?
General
