5-22 DK35/40/450L
INFLATION PRESSURE
Though the tire pressure is factory-set
to the prescribed level, it naturally drops
slowly in the course of time. Thus, check
it everyday and inflate as necessary.
NOTE
Maintain the maximum pressure in
front tires, if using a front loader or
when equipped with a full load of front
weights.
[ ] is when attaching the loader.
Front
Rear
Inflation Pressure
177kPa(1.8kgf/cm
2
,
25.7 psi)
[ 216kPa(2.2kgf/cm
2
,
31.4 psi) ]
Tire Size
(inch)
158kPa(1.6kgf/cm
2
,
22.9 psi)
[ 197kPa(20kgf/cm
2
,
28.6 psi) ]
7-16 4PR
12.4-24 6PR
13.6-24 6PR
8-16 6PR
158kPa(1.6kgf/cm
2
,
22.9 psi)
158kPa(1.6kgf/cm
2
,
22.9 psi)
WARNING
Do not use tires larger than speci-
fied.
Do not attempt to mount a tire.
This should be done by a quali-
fied person with the proper
equipment. Qualified persons
with the proper tire mounting
equipment should recognize the
following warning.
Never exceed 241 kPa (35 psi)
when attempting to seat a bead. If
beads have not been seated by the
time the pressure reaches 241 kPa
(35 psi), deflate the assembly, re-
position the tire on the rim, redu-
plicate and reinflate. After seat-
ing the bead, adjust inflation pres-
sure as recommended in the in-
flation pressure chart.
To Next Page
Loading...
Need help?
General
