Preliminary operation
Both new engine and repaired engine have to do preliminary operation.
1.1 Preparing work before starting
Check all the bolts and nuts to make sure they are tightened.
1.2 Check and add fuel
Check the left fuel level in the fuel tank, and add fuel if necessary.
1.3 Check and add oil
Check the oil level in the oil base pan by oil dip stick, and add the same grade oil to the up limit
if necessary. Pay attention not to overfill the oil more than up limit.
1.4. Check and add cooling water
Check the cooling water level in the radiator and overflow bucket. Add soft water if the cooling
water level is too low. Daily check and adding cooling water can only be operated in the overflow
bucket. If the cooling water level is lower than the lower limit in the overflow bucket, then check
the cooling water in radiator.
1.5 Check the flexibility of governing handle.
The governing handle should be flexible and easy to operate. If there is any block, please
eliminate the problem. If operate each pivot remotely, please add oil. Please adjust the clearance
if it is large.
1.6 Check the alarm system
Make sure the alarms of cooling water, oil pressure are in normal condition. It will cause severe
result if alarm system does not work properly.
To Previous Page
Loading...
Need help?
General
