WORKS OF FELLING TREES AND REMOVING STUMPS
NOTICE
Do not perform stump removal or other hard work by angling tilting the blade.
For trees with a diameter of 10 to 30 cm,
raise the blade high
and push a few times to fell the tree.
Next, travel in reverse, and dig the corner of the blade into the
ground to cut and dig up the roots.
When doing this, never hit the tree at high speed or apply
shock to fell the tree.
SIDE-CUTTING OPERATION
In side cutting operation with unbalanced load on the blade,
use the counter-rotation turn to change the travel direction. As
a result, the operation becomes efficient.
METHOD FOR ADJUSTING WORK EQUIPMENT
For adjusting the play of center ball, see “METHOD FOR ADJUSTING SHIMS AT CENTER BALL”.
METHOD FOR ADJUSTING ANGLE OF BLADE EDGE
Mechanical type pitching rod (variable type)
WARNING
It is dangerous if the work equipment moves by mistake when the blade edge angle is adjusted.
Set
the work equipment in a stable condition, then stop the engine. Set the work equipment lock lever to
LOCK position securely.
OPERATION MACHINE OPERATIONS AND CONTROLS
3-177
To Next Page
Loading...
Need help?
General
