.
MAINTENANCE
SERVICE PROCEDURE
EVERY 250 HOURS SERVICE
Maintenance for every 50 and 100 hours service should be carried out at the same time.
CHECK OIL LEVEL IN DIFFERENTIAL CASE, ADD OIL
WARNING
The parts and oil are at high temperature after the engine is stopped, and may cause burns.Wait for the temperature to go down
before starting the work.
When removing the plug, oil may spurt out, so turn the plug slowly to release the internal pressure, then remove it carefully.
1.
Remove plug (G) and check that the oil level is near the bottom
of the plug hole.
2.
If the oil level is too low, add oil through the plug hole until the
oil overflows.
CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL
WARNING
The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature
to go down before starting the operation.
If there is still pressure remaining inside the case, the oil or plug may fly out. Turn the plug slowly to release the pressure, then
remove it carefully.
1. Stop the machine so that casting line (1) is horizontal and drain
plug (P) is immediately at the bottom.
2.
Remove plug (G) and check that the oil level is near the bottom
of the plug hole.
3.
If the oil level is too low, add oil through the plug hole until the
oil overflows.
4 - 44
To Next Page
Loading...
Need help?
General
