.
MAINTENANCE
SERVICE PROCEDURE
CLEAN DIFFERENTIAL CASE BREATHER
WARNING
The parts and oil are at high temperature after the engine is stopped,
and may cause serious burns. Wait for the temperature to go down
before cleaning the engine breather.
When using compressed air, there is a hazard that dirt may be blown up
and cause serious injury.
Always use safety glasses, dust mask, or other protective equipment.
Remove the mud and dirt from around the breather, then remove the breather and wash out the dirt from inside with
clean diesel oil or flushing oil.
CLEAN ENGINE BREATHER ELEMENT
WARNING
The parts and oil are at high temperature after the engine is stopped,
and may cause serious burns. Wait for the temperature to go down
before cleaning the engine breather.
When using compressed air, there is a hazard that dirt may be blown up
and cause serious injury.
Always use safety glasses, dust mask, or other protective equipment.
1.
Wipe off the dirt from around the breather.
2.
Loosen the clamp, then remove the hose.
3. Remove the bolt, then remove breather (1).
4.
Rinse the whole breather in diesel oil or flushing oil.
5.
After washing, pass diesel oil through in the direction of the
arrow.
6.
Dry with compressed air, then coat the O-ring with oil, and
install.
Check the element and O-ring, and replace them with new
parts if necessary.
7.
Check the breather hose, and if any deteriorated oil is stuck to
the inside, replace the hose with a new hose.
4 - 73
To Next Page
Loading...
Need help?
General
