.
SAFETY
PRECAUTIONS FOR MAINTENANCE
REMOVING BATTERY TERMINAL
When repairing the electrical system or when carrying out electrical welding, remove the negative (-) terminal of the
battery to prevent the flow of current.
PRECAUTIONS WITH HIGH-PRESSURE OIL
The hydraulic system is always under internal pressure. When inspecting or replacing piping or hoses, always
check that the pressure in the hydraulic circuit has been released. If the circuit is still under pressure, it will lead to
serious personal injury, so always do as follows.
For details of the method of releasing the pressure: see the section on "INSPECTION AND ADJUSTMENT". Do
not carry out any inspection or replacement operation before the pressure has been completely removed.
If there is any leakage from the piping or hoses, the surrounding area will be wet, so check for cracks in the piping
and hoses and for swelling in the hoses.
When carry out inspection, wear safety glasses and leather gloves.
There is a hazard that high-pressure oil leaking from small holes
may penetrate your skin or cause blindness if it contacts your
eyes directly. If you are hit by a jet of high-pressure oil and suffer
injury to your skin or eyes, wash the place with clean water, and
consult a doctor immediately for medical attention.
PRECAUTIONS FOR HIGH-PRESSURE FUEL
When the engine is running, high-pressure is generated in the engine fuel piping. When carrying out inspection or
maintenance of the fuel piping system, stop the engine and wait for at least 30 seconds to allow the internal pressure
to go down before starting the operation.
HANDLING HIGH-PRESSURE HOSES, PIPING
If oil or fuel leaks from high-pressure hoses, it may cause fire or defective operation, which may lead to serious
injury. If any loose bolts are found, stop work and tighten to the specified torque. If any damaged hoses are found,
stop operations immediately and contact your Komatsu distributor.
Replace the hose if any of the following problems are found.
Damaged or leaking hydraulic fitting.
Frayed or cut covering or exposed reinforcement wire layer.
Covering swollen in places.
Twisted or crushed movable portion.
Foreign material embedded in covering.
2 - 31
To Next Page
Loading...
Need help?
General
