TRANSPORT AND STORAGE OF LONG REACH MACHINE
NOTICE
• For transportation or storage, always use the support-
ing link (A) to secure the arm (B) and boom (C) as
shown. This will help to prevent excessive force bear-
ing on the boom and arm.
• Other precautions for transport and storage can be
found in "TRANSPORTATION PROCEDURE" of the
standard machine.
Procedure for installing link
Supporting link - weight 30kg.
1.
Lower the boom and extend the arm cylinder to set in the stow posture.
2.
When the arm cylinder is almost at the end of the stroke, lower the boom slowly to bring the bucket or buck-
et link into light contact with the ground.
3.
Remove the end of the supporting link (A) from the boom
(held by a pin (D) and snap ring (E)), then install it to the
arm with the pin (D) and snap ring (E). When doing this,
raise the boom slightly and retract the arm cylinder slightly
from the end of the stroke (5mm - 10mm) to align the holes
correctly.
4.
It is dangerous to carry out this operation with the arm
raised from the ground.
MAINTENANCE
SPECIAL SERVICE REQUIREMENTS FOR 17M LONG REACH WORK EQUIPMENT
CAUTION
When working in water or in wet sand, use molybdenum (LM-P) for the grease.
WARNING
NEVER slew the upper structure of a Long Reach machine if the boom and arm have been removed.
SPECIFICATIONS - 17M LONG REACH
Item
Unit PC360LC-11 (17m Long Reach)
A Overall shipping height  mm 3718
B Overall shipping length  mm 15050
C Transport length  mm 13803
D Track length  mm 4955
E Track length on ground  mm 4030
F Tail swing radius  mm 3770
G Machine tail height  mm 2364
H Overall height of cab  mm 3164
ATTACHMENTS AND OPTIONS 17M LONG REACH BOOM AND ARM
6-25
To Next Page
Loading...
Need help?
General
