Assembly Procedure PC4000
PC4000Asrev05
Edition 08/2005
11
ã
• Before assembling/disassembling, lifting or transporting this
excavator contact your local Service Center for all the
necessary instructions for safe and economic assembling/
disassembling, lifting and transportation procedures of your
excavator.
The sequence of assembly as shown in this Manual. Disassembling is
basically the reverse order of the assembling procedure.
2.3 Transportation and Lifting
The transport dimensions and weights of the excavator’s components
are listed in this manual are for general information only. For the correct
dimensions and weights please refer to the packing list of your
machine.
Observe the operating permits of the low-bed trailers used for
transportation. They contain the permissible load, loading width and
height.
ã
• Observe the federal, state and local laws and regulations for
transportation of heavy units. Know the safety rules and laws
before you transport this Excavator.
• Make sure the flat-bed trailer and the components of the
Excavator are equipped with the correct safety devices.
• Secure the Excavator and all components transported on the
trailer against movement.
• Use exclusively approved handling equipment.
• When lifting components make sure that the handling elements
do not cause damage to the component.
• Secure the components safely before removing the lifting
straps, ropes or chains.
To Next Page
Loading...
Need help?
General
