Assembly Procedure PC4000
PC4000Asrev05
Edition 08/2005
87
3.24 Putting the Central Lubrication System into operation (Z21880)
In order to ensure adequate pre-lubrication of all attachment bearings.
It is necessary to manually lubricate the attachment bearings by
applying a grease gun to the grease fittings on each grease injector.
To this, remove protection cap (3) and press in grease until a grease
collar appears at the connected bearing.
Be sure to repeat the procedure until all pivot bearings of the
attachment and cylinder bearings are lubricated.
W
• Before handing over the excavator to the customer the first
PM Clinic Service has to be carried out according to the
Inspection Procedure Manual.
To Next Page
Loading...
Need help?
General
