Security Function Ver. 1.01 Feb. 2017 7. Enhancing the security function
12
7. Enhancing the security function
• Perform the Enhanced Security Mode procedures while making checks of installation
checklist in User’s Guide [Security Operations].
• To make the Enhanced Security Mode, service settings must first be made. Make the
necessary service settings and check that they have been correctly made.
7.1 Details of settings
NOTE
• If any one of the above functions is not set properly, the machine does not allow
the Enhanced Security setting to be made.
• The CE password must be set to any value other than the default one.
• If fax functions are to be used, check that the fax kit has been mounted and set up
properly.
See P.45
• In addition to setting the Enhanced Security Mode, the service engineer disables
the following functions and operates and manages the machine under a condition
in which those functions are disabled.
Item Setting/Check Default Setting
CE Authentication Check the setting of [ON] [ON]
CE Password Set arbitrarily. 9272927292729272
HDD installation setting Check the setting of [Installed]. [Installed]
Management Function Choice Check the setting of [Unset]. [Unset]
Item Setting
IP Address Fax
Using [Service Mode]
→ [System 2] → [Network Fax Settings],
set [IP Address Fax] to [OFF].
Internet Fax
Using [Service Mode]
→ [System 2] → [Network Fax Settings],
set [Internet Fax] to [OFF].
To Next Page
Loading...
Need help?
General
