Security Function Ver. 1.01 Feb. 2017 7. Enhancing the security function
17
NOTE
• Make sure that the Administrator Password has been changed to one that meets
the requirements of the Password Rules.
7.2.3 Functions disabled by the setting of Enhanced Security Mode
• Note that setting Enhanced Security Mode to “ON” disables the following functions.
(1) Terminal Debug (forcibly prohibited when Enhanced Security Mode is set to
“ON”)
(2) Print Data Capture (forcibly prohibited when Enhanced Security Mode is set to
“ON”)
(3) In CS Remote Care, the following operation is prohibited.
Rewriting instructions of firmware, communication of the account track counter
information, the setting renewal of the machine, the function of remote counter
management
(4) Firmware upgrading through Internet ISW (Machine Update Setting) (When the
Enhanced Security Mode is set to ON, the setting of this function cannot be
changed from “OFF.”)
7.2.4 Functions whose settings are changed by Enhanced Security Mode
• Setting the Enhanced Security Mode to [ON] changes the setting values of the following
functions.
NOTE
• When attempting to change settings that have been changed in conjunction with
the Enhanced Security Mode, the screen to release Enhanced Security Mode may
be displayed for some settings. Note that if run, this will release Enhanced Secu-
rity.
• In addition, the indicator of “not be changed” below indicates that the settings
cannot be changed while Enhanced Security Mode is maintained “ON”.
User Authentication Check that [Authenticate] (External sever type is
“Active Directory” only) is set.
[OFF]
SSL Check that the registration of the self-certificate is
performed to perform SSL communication
No setting
Enhanced Security Mode Set to [ON]. [OFF]
Function Name Default Setting
When Enhanced Security mode is set to
[ON]
Password Rules
• To apply the password rule to
enhance security.
Disable Enable (not to be changed)
Prohibited Functions When
Authentication Error
• To set the function for prohibit-
ing Authentication operation in
order to prevent the unautho-
rized access.
Mode 1 Mode 2 (not to be changed): Three times is
set.
* The number of times can be changed to
once, twice, or three times.
Release Time Settings
• To set the period of time to be
elapsed before the access lock
state is released.
5 min. The setting value should be 5 min. or more
(no value less than 5 can be set)
To Next Page
Loading...
Need help?
General
