3
3. Installation of the machine and steps to be
performed before operationSecurity Function Ver. 1.01 Feb. 2017
3.1.9 Performing Non-Image Area Erase Check
Perform the below at the site where customer uses the machine.
1. Touch these keys in this order: [Service Mode] → [Machine] → [Non-Image Area Erase
Check].
2. Open fully the dual scan document feeder, the reverse automatic document feeder, or
the original cover if loaded.
• Do NOT place a document on the document glass.
• Clean the document glass if dirty.
3. Press the Start key.
4. Make sure that “Result” is “OK”. If “Result” is “NG1” or “NG2”, review the place and
direction of installation, or take measures to block the light source (by covering it, etc.),
then perform installation checking again. If a fluorescent light or other bright light
sources exist right above the machine, the light source can hinder installation checking
and cause operation errors in the Non-Image Area Erase Check.
5. Touch “OK.”
3.1.10 Configuring other options
1. See the “Configuration procedures” of the installation manual for each option.
3.1.11 Restarting the machine
1. Open the front door and turn OFF the power switch.
2. Turn ON the power switch again after 10 or more seconds have passed, then close the
front door.
3.1.12 Adjusting each option
1. See the “Adjustment procedures” of the installation manual for each option.
3.1.13 Connecting the network cable
1. Connect the main body and networking equipment (HUB) using the network cable. The
following shows the recommended network cables that correspond to each communi-
cation speed.
• 10BaseT/100BaseTX: Category5
• 1000BaseT: Category5E, Category6
2. Check LEDs for lighting conditions.
• LED1: Should light up steadily if the link network connection has been made.
• LED2: Should blink according to the communications status of the ACT network.
3. Route the network cable.
3.1.14 Network setting
Make the TCP/IP address setting for the network. Consult the network administrator for the
setting value to be entered and make settings as required.
1. Touch these keys in this order: [Utility] → [Administrator Settings] → [Network Settings]
→ [TCP/IP Settings] → [IPv4 Settings].
2. Touch “Manual Input” of IP Application Method and make the following settings.
IP Address: IP address of the controller
Subnet Mask: Subnet mask of the network, to which the machine is connected
Default Gateway: IP address of the default gateway
3. Touch “OK.”
4. Touch “OK” after the “TCP/IP Settings” screen is displayed.
To Next Page
Loading...
Need help?
General
