72
Communication
This instrument can be used together with PC for mutual communication. Use the USB
cable (2m) CS-A32 supplied as standard accessory for this purpose.
The USB cable is allowed to plug/unplug while power is on, but it is recommended to
switch power off in this case.
Operation Procedure
1. Switch power OFF (O).
2. Connect the USB cable to the USB
connector of this instrument.
3. Make sure that USB cable is all seated to
the USB connector.
Communication interface in this instrument conforms to USB1.1.
Hold the USB cable plug in unplugging. Do not pull the cord.
Plug the USB cable to fit the connector entry point.
To connect this instrument to PC, install the corresponding USB driver software. It is
attached to the data management software CS-S10w Professional in the standard
accessories. See installation guide of CS-S10w Professional for details on installing the
USB driver software to PC.
Connecting to PC
To Next Page
Loading...
Need help?
General
