Security Function Ver. 1.02 Mar. 2016 5. Checking the firmware version number
8
5. Checking the firmware version number
• Confirm the need to enhance or not to enhance the security function with the administra-
tor of this machine: If administrator wants to enhance, check the firmware version (MFP
Card Version, MFP Controller BOOT Program).
• If the firmware version number of this machine is different from numbers shown in the list
below, it will be necessary to re-write to the firmware version corresponding to security.
Refer to P.37 for the method of how to re-write the firmware.
5.1 Security authentication firmware version number
Refer to P.20 for the method of checking the firmware version.
6. Accessing the Service Mode
6.1 Access method to the Service Mode
1. Press Menu.
2. Touch [Counter].
3. Touch [Display Keypad].
4. Press the following keys in this order:
Stop → 0 → 0 → Stop → 0 → 1
5. Enter the CE password.
NOTE
• Authentication using the CE password is carried out only if “ON” is set for
[CE Authentication] as accessed through [Service Mode] → [Enhanced Security].
NOTE
• The CE password entered is displayed as “✱.”
• NEVER forget the CE password. When forgetting the CE password, call responsi-
ble person of KONICA MINOLTA (hereafter called KM).
MFP Card Version MFP Controller BOOT Program
bizhub 367/287/227 A7AH0Y0-F000-G00-27 A7AH0Y0-1E00-G00-01
A7AHS1E001DA
To Next Page
Loading...
Need help?
General
