Security Function Ver. 1.02 Mar. 2016 7. Enhancing the security function
16
19. Check that [UnSet] is selected and then touch [END].
7.2.2 Requests to the administrator
• When making the Enhance Security setting, the Administrator settings must first be
made. The administrator must perform or check the following settings.
NOTE
• Make sure that the Administrator Password has been changed to one that meets
the requirements of the Password Rules.
• If the administrator of the machine registers a new Encryption Key when the
Enhanced Security is to be made, be sure first to perform [Physical Format] by
accessing [Service Mode] → [State Confirmation] → [Memory/Storage Adjust-
ment] → [Format].
7.2.3 Functions disabled by the setting of Enhanced Security Mode
• Note that setting Enhanced Security Mode to “ON” disables the following functions.
(1) Terminal Debug (forcibly prohibited when Enhanced Security Mode is set to
“ON”)
(2) Print Data Capture (forcibly prohibited when Enhanced Security Mode is set to
“ON”)
(3) In CS Remote Care, the following operation is prohibited.
Rewriting instructions of firmware, communication of the account track counter
information, the setting renewal of the machine, the function of remote counter
management
A7AHS1E011DA
Item Setting/Check Default Setting
Administrator Password Check that the password meets the requirements
of the Password Rules.
1234567812345678
Encryption Key Setting of encryption key. No setting
User Authentication Check that [Authenticate] (External sever type is
“Active Directory” only) is set.
[OFF]
SSL Check that the registration of the self-certificate is
performed to perform SSL communication
No setting
Enhanced Security Mode Set to [ON]. [OFF]
To Next Page
Loading...
Need help?
General
