Result and Error Codes
Syntax
In case of an error, the device responds with an error message. The error message syntax:
• ~NN@ERR XXX<CR><LF> – when general error, no specific command.
• ~NN@CMD ERR XXX<CR><LF> – for specific command.
• NN – machine number of device, default = 01.
• XXX – error code.
Error Codes
ERR_COMMAND_NOT_AVAILABLE
ERR_PARAMETER_OUT_OF_RANGE
Not enough space for data (firmware, FPGA…)
Not enough space – file system
ERR_FEATURE_NOT_SUPPORTED
Packet number isn't expected (missing packet)
File has the same CRC – no changed
Device/chip was not initialized
To Next Page
Loading...
Need help?
General
