Check that the coffee beans do not contain any foreign particles such as grit, as any damage caused by the
presence of foreign particles will void the warranty. Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or scalding you.
Be sure that the drip tray is properly installed to avoid overflow. Be sure you water tank is clean.
9
There are three fineness settings on this grinder. You can adjust the fineness to select your own personal preferences.
The finer the grind, the stronger the flavour. To change the grind, turn the knob during the grinding process.
CHANGE THE SETTING DURING GRINDING.
NEVER FORCE THE GRINDING FINENESS SETTING KNOB.
SUGAR COATED, FLAVOURED OR OILY COFFEE / ESPRESSO BEANS CAN CLOG THE GRINDER.
We do not recommend the use of oily or sugar coated or flavored espresso/coffee beans. These types of beans may
damage the machine.
DO NOT PUT YOUR HANDS UNDER THE OUTLETS WHEN RINSING PROCESS IS IN PROGRESS.
HOT WATER COMES OUT THROUGH THEM AND MAY CAUSE SCALDING
Do not fill the water tank with hot water, mineral water, milk or any other liquid. If you turn on the machine when
the water tank is not in place or not correctly filled (under the “min.” level,), the “fill water tank” light will come on.
This machine will not operate when the water tank is empty.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
ADJUSTING THE GRINDER
Pull out and fill the
water tank with fresh
water.
Replace the tank, press
firmly to ensure it is fitted
properly. Close the lid.
Open the coffee bean
container lid. Add fresh
coffee or espresso beans.
Close the coffee bean
container lid again.
Turn clockwise
for a coarser
grind.
Turn counter-
clockwise for
a finer grind.
PREPARING THE MACHINE FOR FIRST USE
RINSING OF THE CIRCUITS
Press the key
to turn your
machine on. The
light will flash
then become
solid when the
operating
temperature has
been reached.
Rinsing of the cof
fee
circuit:
Place a 0.5 l/17 oz under
the coffee outlets and
steam nozzle. Press
briefly the "Service" key
to start the rinsing of the
coffee circuit cycle that
will automatically stop
after 40 ml/1.3 oz.
You should periodically rinse the machine. We recommend rinsing the machine if it has not been used for serveral days.
Rinsing of the steam
circuit:
Then press for 3
seconds the "Service"
key to start the rinsing
of the steam circuit, that
will stop automatically
after about
300 ml/10.14 oz.
1s
3s
To Next Page
Loading...
Need help?
General
