8
ENGLISHFRANÇAISESPAÑOL
Machines are
pre-set in the factory
to 2, average
temperature.
At each stage you can store desired settings by pressing the key or continue the procedure.
The settings will remain memorised even if there is a power failure.
You can change these settings at anytime by repeating the same operations.
Press the key as
many times as are needed
to select the hardness
level for the water used.
Machines are
pre-set in the factory
for hardness level 3.
Machines are
pre-set in the factory
to shut-off after 1 hour
of non-use.
1
2
3
1 = 1 H
2 = 2 H
3 = 3 H
4 = 4 H
0 = very soft
1 = soft
2 = moderately hard
3 = hard
4 = very hard
Press the steam key to
switch to automatic
cut-off setting =>
You can program the
automatic shut-off
of your machine.
Press the steam key to
switch to coffee
temperature setting =>
The digital display for
parameter setting is
under the servicing flap.
Press the ‘Service’ and
keys at the same
time.
Look down vertically to
the bottom of the win-
dow.
Lift the cup tray by
pressing on the back to
make it tilt.
Connect the machine to
the mains power supply
but do not turn it on.
Before you first use your machine, it will ask you to set several parameters. Please note, if you disconnect the machine from
the power source, you will need to complete parts of this process again.
The ‘water tank‘ light
will come on.
Press the key as
many times as are
needed to select the
desired coffee temperature.
The ‘calc’ light will
come on.
The ‘clean’ light will
come on.
Press the key as
many times as are
needed to select the
desired duration.
SETTING WATER HARDNESS
SETTING THE COFFEE TEMPERATURE
MACHINES AUTOMATIC SHUT-OFF FEATURE
INITIAL SET-UP
To Next Page
Loading...
Need help?
General
