We recommend that you use pasteurised 1 or 2% milk. The milk should be quite cold, ideally between
42° F and 50° F (6 and 10° C). After having used the steam or hot water functions, the nozzle may be
hot, and we recommend that you wait for a few moments before handling it.
To remove any remaining
milk from the steam nozzle,
place a receptacle under
the steam nozzle and
press the button .
...again press the “steam”
button to stop the cycle.
Cycle do not stop immediately.
Press the button.
The light will flash while the machine heats up.
Once the pre-heating phase has been completed, the light will remain on continuously and you can start
producing steam by again pressing the button.
A little water will be produced first and then steam will start. Press the same button to stop steam generation.
11
USING STEAM
FROTHING MILK
To interrupt the steam function, just press any button. Be careful as the nozzle may be hot.
If the nozzle is blocked, clean it out with the needle included in the machine.
The maximum duration for production of steam per cycle is limited to 2 minutes.
AUTO-CAPPUCCINO ACCESSORY (SOLD SEPARATELY)
To prevent the milk drying on and in the auto-cappuccino accessory we strongly recommend that you immediately :
- put clean water inside the jug and reinstall the different components
- run a “steam” cycle
- clean all parts with a moist cloth.
You can also use our special XS 4000 cleaner for milk systems.
Steam is used to froth milk (for cappuccino / latte) but can also be used to reheat other liquids. As you
need a higher temperature to produce steam than to make an espresso, the machine runs an additional
pre-heating phase for steam.
Check that the steam
nozzle is correctly
fitted.
Fill a frothing pitcher
one-third and immerse
the nozzle in the milk.
Run for at least
10 seconds, then again
press the steam
button to stop
generating steam.
Once your milk is frothy
enough to your liking...
Activate the steam
function as explained
above.
You can remove the steam nozzle for thorough cleaning. Wash it
using a brush with water and a little non-abrasive dish soap.
Rinse and dry it. Before re-fitting, make certain that the air inlet holes are not
clogged by milk residue. If necessary clean out the holes with the needle
delivered with the machine. Do not put the steam nozzle in the dish washer.
Caution, steam cycle does not stop immediately.
Join the various components to each other.
Choose the cappuccino or caffe latte posi-
tion of the special steam nozzle.
Cleaner for
milk systems.
Fill in the milk recipient and
place a cup or a glass under
the auto-cappuccino nozzle.
Press the key to launch
and then stop the cycle
.
Place your cup or glass under
the coffee outlet and launch
the coffee/espresso cycle.
The auto-cappuccino accessory makes it easy to prepare a cappuccino or a caffe latte. It is comprised of a special nozzle with
two-positions/markings and a brushed stainless steel milk jug and tubes.
XS 6000
XS 4000
To Next Page
Loading...
Need help?
General
