13
1 – Cleaning cycle
The ‘clean’ light becomes solid.
The cleaning cycle will be run automatically.
Water is pumped intermittently. This operation lasts about
10 minutes and the ‘clean’ light will then flash again.
2 - First rinsing
The ‘clean’ light will become solid again.
The program continues.
A first rinsing cycle will be run automatically. It allows the
machine to be rinsed and any remaining detergent to be
eliminated. This first rinsing cycle lasts about 5 minutes and
once finished the ‘clean’ light will flash again.
Again press the ‘Service’
button to start the
second rinsing cycle.
3 – Second rinsing
The ‘clean’ light again becomes solid.
A second cleaning cycle will be run automatically. This second
rinsing cycle lasts about 5 minutes.
Once the second rinsing cycle has finished, the ‘clean’ light
will go off.
Your machine will be ready
for use again.
±±
10 min.
±
5 mn
±±
5 mn
Press the ‘Service’
button to start up the
cleaning program.
Open the servicing flap
and insert a Krups clea-
ning tablet (XS3000) in
the cleaning tablet pipe.
Empty your waste water
container and put it back
under the coffee outlets.
Again press the ‘Service’
button to start the first
rinsing cycle.
Empty your waste water
container and put it back
under the coffee outlets.
Fill your water tank.
Empty the drip tray and
fit it again.
Remove and empty your
waste water container.
XS3000
If there is not enough water in the water tank when you start the program, the “fill water tank” light will come
on to warn you. Add the appropriate amount of water to the container and cleaning will continue automatically.
If you press the ‘ ’ key during cleaning or in the event of power failure, you will have to restart the cleaning
program right from the start. This is essential due to water circuit rinsing reasons. In this case, you will need to use
another cleaning tablet. Be sure to complete the entire cleaning cycle to avoid any risk of irritation (seek medical
advice if cleaning solutions are accidently swallowed).
The cleaning cycle is a continuous cycle. Do not put your hands under the coffee outlets during the cycle.
Only use Krups (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result from
the use of tablets from other brands. You can obtain cleaning tablets from Krups Service Centres.
Make certain to protect your work surface during cleaning cycles, especially if they are
made of marble, stone or wood.
To Next Page
Loading...
Need help?
General
