7 PREPARING FOR USE 19
– Change the piston every 10 operating hours.
7.5 Preparing for rides on wet sand
M01129-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the required value:
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
– Do not open the radiator, the radiator hoses or other cooling sys-
tem components if the engine or the cooling system are at oper-
ating temperature.
– Allow the cooling system and the engine to cool down before you
open the radiator, the radiator hoses or other components of the
cooling system.
– In the event of scalding, rinse the area affected immediately
with lukewarm water.
– Change the radiator cap.
M01106-01
– Fit a waterproofing device on the air filter.
Waterproofing device for air filter (79006921000)
Info
See the KTM PowerParts fitting instructions.
M01107-01
– Adjust the carburetor jetting and setting.
Info
Your authorized KTM workshop can recommend the right carburetor tuning.
600868-01
– Clean the chain.
Chain cleaner ( p. 105)
– Fit the steel sprocket.
Tip
Do not grease the chain.
– Clean the radiator fins.
– Straighten bent radiator fins carefully.
Condition
Regular use in sand
– Change the piston every 10 operating hours.
To Next Page
Loading...
Need help?
General
