16 SERVICE WORK ON THE ENGINE 87
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
– Always make sure there is sufficient ventilation when running the
engine.
– Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
– Start the engine and check that it is oil-tight.
Finishing work
– Check the gear oil level. ( p. 85)
16.4 Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
Preparatory work
– Park the motorcycle on a level surface.
A00028-10
Main work
–
Remove gear oil level check screw
1
.
401955-11
–
Remove filler plug
2
.
– Add gear oil until it emerges from the drill hole of the gear oil monitoring screw.
Engine oil (15W/50) ( p. 103)
– Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check M6 8 Nm (5.9 lbf ft)
–
Mount and tighten filler plug
2
.
Finishing work
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
– Always make sure there is sufficient ventilation when running the
engine.
– Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
– Start the engine and check that it is oil-tight.
To Next Page
Loading...
Need help?
General
