11 SERVICE WORK ON THE CHASSIS 58
11.39 Checking the frame
K00519-01
– Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
– Change the frame.
Info
Always replace a frame that has been damaged due to a mechanical
impact. Repair of the frame is not authorized by KTM.
11.40 Checking the swingarm
500285-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
– Change the swingarm.
Info
Always change a damaged swingarm. Repair of the swingarm is not
authorized by KTM.
11.41 Checking the throttle cable routing
Warning
Danger of accidents The throttle cable may slip out of the guide if routed incorrectly.
The throttle slide will then no longer be closed and the speed can no longer be controlled.
– Make sure that the throttle cable routing and the play in throttle cable complies with the specification.
Preparatory work
– Remove the seat. ( p. 48)
–
Turn handle
1
of the fuel tap to the OFF position. (Figure K00858-10 p. 13)
– Remove the fuel tank. ( p. 52)
K00865-01
Main work
– Check the throttle cable routing.
The throttle cable must be routed along the back of the handlebar, to the right of
the frame, above the fuel tank bracket, and to the carburetor. The throttle cable
must be fixed on the fuel tank bracket with a rubber band.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
Finishing work
– Install the fuel tank. ( p. 53)
– Mount the seat. ( p. 48)
To Next Page
Loading...
Need help?
General
