KTM 2010 990 Super Duke User Manual

MAINTENANCE WORK ON FRAME AND ENGINE 96
700661-01
– Check the wheel bearing for damage and wear.
» If the wheel bearing is broken or worn:
–
Replace the wheel bearing. x
– Remove bushing  and bushing . Clean and grease the roll surfaces of the bushing
and the shaft seal rings.
Long-life grease ( p. 189)
– Fit the bushings.
– Clean and grease the thread of the wheel spindle and nut.
Long-life grease ( p. 189)
– Clean the fixing locations on the brake caliper support and swingarm.

KTM 2010 990 Super Duke Specifications

General

Displacement	999 cc
Bore x Stroke	101 mm x 62.4 mm
Compression Ratio	11.5:1
Fuel System	Electronic Fuel Injection
Transmission	6-speed
Rear Suspension	WP monoshock
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR 17
Engine Type	LC8, 75° V-twin
Power	120 hp (89 kW) @ 9, 000 rpm
Torque	100 Nm
Frame	Steel trellis frame
Front Suspension	WP 48 mm USD forks
Front Brake	Dual 320 mm discs
Rear Brake	240 mm disc
Dry Weight	186 kg
Fuel Capacity	18.5 liters

Summary

Owner's Manual Overview

Important Information

Key details on safety, maintenance, warranty, spare parts, and work rules.

Controls and Instruments

Handlebar Controls

Operation of clutch, brake levers, lights, horn, ignition, and starter.

Combination Instrument

Explanation of speedometer, tachometer, indicators, and display functions.

Operation and Riding Instructions

Tips on Putting into Operation

Initial use, engine break-in, and vehicle loading advice.

Riding Instructions

Guidance on starting, shifting, braking, and refueling.

Service and Maintenance

Service Schedule

Recommended maintenance intervals and tasks for various service points.

Maintenance Work

Procedures for frame, engine, brakes, wheels, electrical, and cooling systems.