6 CONTROLS
18
6.9 Stop button
W00296-10
The stop button
1
is located on the right side of the handlebar.
Possible states
• The stop button is in the basic position – In this position,
the ignition circuit is closed and the engine can be started.
• Stop button pressed – In this position, the ignition circuit
is interrupted, a running engine stops, and a non-running
engine will not start.
6.10 Combination switch
W00016-10
The combination switch is fitted on the left side of the handlebar.
Possible states
1 STANDARD – STANDARD mapping is activated when
the indicator lamp
A
lights up.
2 ADVANCED – ADVANCED mapping is activated when
the indicator lamp
B
lights up.
The engine characteristic can be changed using button
1
and
button
2
on the combination switch.
Info
If no combination switch is installed, the last selected
mapping is activated.
If a combination switch has never been mounted, the
STANDARD mapping is activated.
6.11 Overview of indicator lights (All EXC models)
E00860-01
Possible states
The high beam indicator lamp lights up blue – The
high beam is switched on.
Malfunction indicator lamp lights up/flashes yellow
– The OBD has detected a malfunction in the vehi-
cle electronics. Come safely to a halt, and contact an
authorized KTM workshop.
The fuel level warning lamp lights up yellow – The
fuel level has reached the reserve mark.
Turn signal indicator lamp flashes green – The turn
signal is switched on.
The oil level warning lamp lights up red – Oil level has
reached the MINmarking. Ride for no more than until
the remaining fuel in the tank is depleted and at the
next opportunity refuel with 2-stroke oil.
To Next Page
Loading...
Need help?
General
