KTM 300 EXC TPI 2018 User Manual

12 SERVICE WORK ON THE CHASSIS
98
E00892-10
– Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
– Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
– Remove the bleeding syringe. Tighten the bleeder screw.
– Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
– Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.46 Removing the engine guard (All Six Days models)
H01638-10
–
Remove screws
1
and engine guard.
12.47 Installing the engine guard (All Six Days models)
H01638-10
– Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)

KTM 300 EXC TPI 2018 Specifications

General

Brand	KTM
Model	300 EXC TPI 2018
Category	Motorcycle
Language	English