SERVICE WORK ON THE CHASSIS 46
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
Preliminary work
– Remove the seat. ( p. 41)
–
Remove the fuel tank. x ( p. 44)
– Check the throttle cable routing. ( p. 51)
B00316-11
Main work
– Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
– Make sure that no cables are trapped or damaged.
– Mount the fuel tank breather.
– Mount and tighten screw 1 with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
B00315-11
– Mount and tighten screws 2 with the collar bushing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
100922-11
– Connect the electrical plug-in connection 3.
– Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
– Remove the wash cap set. Lubricate the O-ring and connect plug-in connection 4
of the fuel line.
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Subsequent work
– Mount the seat. ( p. 41)
10.34Checking for chain dirt accumulation
400678-01
– Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
– Clean the chain. ( p. 47)
To Next Page
Loading...
Need help?
General
