SERVICE WORK ON THE CHASSIS 51
10.41Checking the swingarm x
500285-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm. x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by KTM.
10.42Checking the throttle cable routing
Preliminary work
– Remove the seat. ( p. 41)
–
Remove the fuel tank. x ( p. 44)
101286-10
Main work
– Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve body side by side behind
the handlebars and above the tank bearing.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
Subsequent work
–
Install the fuel tank. x ( p. 45)
– Mount the seat. ( p. 41)
10.43Checking the rubber grip
401197-01
– Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
» If a rubber grip is damaged, worn or loose:
– Change and secure the rubber grip.
Rubber grip adhesive (00062030051) ( p. 99)
10.44Additionally securing the rubber grip
Preliminary work
– Check the rubber grip. ( p. 51)
401198-01
Main work
– Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rub-
ber grip.
To Next Page
Loading...
Need help?
General
