ELECTRICAL SYSTEM 15
85
– Disconnect the negative cable of the 12-V battery to avoid
damage to the onboard electronics.
V02564-10
Main work
– Connect a battery charger to the 12-V battery. Connect the
battery charger to the mains connection.
Battery charger (58429074200)
It is impossible to overcharge the 12‑V battery using this bat-
tery charger.
This battery charger is not suitable for lithium-ion batteries.
Info
Charge the 12-V battery to a maximum of 10 % of the
capacity specified on the battery housing.
– Switch off the battery charger after charging and disconnect
from the 12-V battery.
Guideline
The charging current, charging voltage, and charging time
must not be exceeded.
Recharge the 12-V battery
regularly when the motorcy-
cle is not being used
3 months
– Position the negative cable and mount and tighten the screw.
– Position the negative terminal cover.
Finishing work
– Mount the front rider's seat. ( p. 69)
– Mount the passenger seat. ( p. 68)
– Set time and date. ( p. 45)
15.4 Changing the main fuse
Warning
Fire hazard Incorrect fuses overload the electrical system.
– Only use fuses with the required ampere value.
– Do not bypass or repair fuses.
Info
The main fuse protects all electrical power consumers of the vehicle. The main fuse is under the seat.
Preparatory work
– Remove the passenger seat. ( p. 68)
– Remove the front rider's seat. ( p. 69)
To Next Page
Loading...
Need help?
General
