MAINTENANCE ON CHASSIS AND ENGINE 74
9.20Adjusting the fork offset x
Info
The left and right fork offset should have the same settings.
The operations are the same on the left and right.
– Jack up the vehicle. ( p. 50)
300274-11
– Remove screws with bushings .
– Place the A-arm with bushings in the desired position. Mount and tighten screws .
Guideline
Screw, A-arm top M10x52 45 Nm
(33.2 lbf ft)
– Remove the vehicle from the work stand. ( p. 50)
9.21Toe width of rear axle
301794-10
The toe width can be adjusted by installed the spacer in various ways.
Difference between
narrow/wide toe
76 mm (2.99 in)
To Next Page
Loading...
Need help?
General
