KTM 85 SX 17/14 User Manual

11 SERVICE WORK ON THE CHASSIS 49
11.38 Adjusting the chain guide x
L00078-10
– Loosen screws 1. Remove screw 2. Swing the chain guide down.
Condition
Number of teeth: ≤ 44 teeth
– Insert collar bushing into drill hole A. Position the chain guide.
– Mount and tighten screw 2. Tighten screw 1.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
Condition
Number of teeth: ≥ 45 teeth
– Insert collar bushing into drill hole B. Position the chain guide.
– Mount and tighten screw 2. Tighten screw 1.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
11.39 Checking the frame x
401542-01
– Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame. x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by KTM.
11.40 Checking the swingarm x
401543-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm. x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by KTM.
11.41 Checking the routing of the throttle cable
Warning
Risk of injury The throttle cable can slip out of the guide; if this happens, the throttle slide can no longer be closed and the
speed cannot be controlled.
– Always ensure that the throttle cable is correctly routed and check the throttle cable play.
Preparatory work
– Remove the seat. ( p. 40)
–
Remove the fuel tank. x ( p. 44)

KTM 85 SX 17/14 Specifications

General

Brand	KTM
Model	85 SX 17/14
Category	Motorcycle
Language	English