KTM 85 SX 17/14 User Manual

16 SERVICE WORK ON THE ENGINE 74
L00075-10
Main work
– Remove oil drain plug 1 with the magnet.
– Completely drain the gear oil.
– Thoroughly clean the oil drain plug with a magnet.
– Clean the sealing surface on the engine.
– Mount the oil drain plug with the magnet and seal ring and tighten it.
Guideline
Oil drain plug with magnet M10 20 Nm
(14.8 lbf ft)
16.4 Filling up with gear oil x
Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
L00072-11
Main work
– Remove filler plug 1 and fill up with gear oil.
Gear oil 0.50 l (0.53 qt.) Engine oil (15W/50) ( p. 86)
– Mount and tighten filler plug 1.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Finishing work
– Check the gear oil level. ( p. 73)
16.5 Adding gear oil x
Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
Preparatory work
– Stand the motorcycle upright on a horizontal surface.
L00075-11
Main work
– Remove screw 1.
L00072-10
– Remove filler plug 2.
– Add gear oil until it flows out of the bore of the gear oil level screw.
Engine oil (15W/50) ( p. 86)
– Mount and tighten screw 1.
Guideline
Screw, engine case M6x25 10 Nm (7.4 lbf ft)
– Mount and tighten filler plug 2.

KTM 85 SX 17/14 Specifications

General

Brand	KTM
Model	85 SX 17/14
Category	Motorcycle
Language	English