TROUBLESHOOTING »
Indicator lamp blink code
FI
The blink code (FI indicator lamp) indicates which component is affected by an error. This allows the error to be identified if no diagnosis
tool is available. The rhythm of the blinking lamp will let you determine the two-digit „blink code“,
e.g.: Blink code 34: FI blinks 3x long, 4x short, pause, Blink code 06: FI blinks 6x short, pause
TROUBLE CAUSE REMEDY
The battery is discharged The ignition (power consumer)
hasn’t been switched off
The battery isn’t charged by the
generator because
Recharge the battery according to the relevant instructions
Voltage regulator and generator should be checked by an
authorized KTM workshop
No values are visible in the com-
bined instrument display
Blown fuse Replace fuse HORN BRAKELIGHT SPEEDO
The speed indication on the com-
bined instrument is not working
Defective sensor cable or oxidized
socket connector
Check the pickup cable for damage, remove the headlight mask
and check the cable connectors,
contact an authorized KTM workshop
BLINK CODE SIGNAL / COMPONENT ERROR DESCRIPTION
02 Pulse generator Malfunction
06 Throttle sensor Output signal too low /high
07 Sensor for 2nd throttle valve Output signal too low /high
09
Intake manifold air pressure for sensor rear cylinder
Output signal too low /high
11
Intake manifold air pressure sensor for front cylinder
Output signal too low /high
12 Coolant temperature sensor Output signal too low /high
73
To Next Page
Loading...
Need help?
General
