MAINTENANCE WORK ON FRAME AND ENGINE 100
700578-01
– Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
– Remove screws.
– Remove cover with membrane .
– Add brake fluid to the MAX level.
Brake fluid DOT 4 / DOT 5.1 ( p. 206)
– Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
9.26Brake linings
The brake linings fitted by KTM have been tested over long periods and guarantee optimal braking characteristics. The type names of the
brake linings are entered in the homologation documents.
Info
Brake linings available in accessories shops are often untested and unapproved for use on KTM vehicles. The structure and friction
coefficient of the brake linings, and therefore the brake power, can vary considerably from the original KTM brake linings. If brake
linings other than those supplied as originals are used, there is no guarantee that they correspond to the original homologation. The
vehicle then no longer corresponds to the condition at delivery and the guarantee is no longer valid.
9.27Checking the front brake linings
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
– Change worn brake linings immediately. (Your authorized KTM workshop will be glad to help.)
To Next Page
Loading...
Need help?
General
