KTM 990 Supermoto R User Manual

MAINTENANCE WORK ON FRAME AND ENGINE 107
700641-01
– Check the wheel bearing for damage and wear.
» If the wheel bearing is broken or worn:
–
Replace the wheel bearing. x
– Grease and mount the left and right spacers and the shaft seal rings.
Long-life grease ( p. 211)
– Clean screw  and wheel spindle .
– Lift the front wheel into the fork, position it, and insert the wheel spindle.
– Mount and tighten screw .
Guideline
Bolt, front axle M25x1.5 45 Nm
(33.2 lbf ft)
700639-11
– Position the brake calipers and check that the brake linings are seated correctly.
– Mount screws  on both brake calipers but do not tighten yet.
– Operate the hand brake lever repeatedly until the brake lining presses up against the
brake disc and there is a pressure point. Fix the hand brake lever in its engaged posi-
tion.
The brake calipers straighten.
– Tighten screws  on both brake calipers.

KTM 990 Supermoto R Specifications

General

Engine Type	V-twin, 4-stroke
Displacement	999 cc
Transmission	6-speed
Seat Height	875 mm
Dry Weight	191 kg
Bore x Stroke	101 mm x 62.4 mm
Compression Ratio	11.5:1
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
Front Suspension	WP USD 48mm
Rear Suspension	WP monoshock
Front Tire	120/70 ZR 17
Rear Tire	180/55 ZR 17
Wheelbase	1505 mm
Starter	Electric
ABS	Optional
Torque	97 Nm
Rear Brake	Single 240 mm disc
Frame	Chromoly trellis
Front Brake	2 x 305 mm discs