CONTROLS 15
5.16Querying lap time
Info
This function can be called up only if lap times are measured.
Condition
The motorcycle is stationary.
400321-01
– Press the button briefly and repeatedly until LAP appears at the bottom right of
the display.
– Press the button briefly.
LAP 1 appears on the left side of the display.
– Laps 1-10 can be displayed by pressing the button .
– The button has no function.
– Press the button briefly.
Next display mode
Info
If an impulse is received from the wheel speed sensor, the left side of the
display changes back to the SPEED mode.
5.17Display mode SPEED (speed)
400317-02
– Press the button briefly and repeatedly until SPEED appears on the left side of
the display.
The current speed is displayed in the SPEED display mode.
The current speed can be displayed in Km/h or Mph.
Info
Making the setting according to the country.
When an impulse comes from the front wheel, the left side of the speedometer
display changes to the SPEED mode and the current speed is shown.
5.18Display mode SPEED/H (operating hours)
400316-01
Condition
• The motorcycle is stationary.
– Press the button briefly and repeatedly until H appears at the bottom right of the
display.
In display mode H, the operating hours of the engine are displayed.
The operating hours counter stores the total traveling time.
Info
The operating hours counter is necessary for ensuring that maintenance work is
carried out at the right intervals.
If the speedometer is in H display mode at the start of the journey, it automati-
cally changes to the ODO display mode.
The H display mode is suppressed during the journey.
Press the button . No function
Press the button . No function
Press the button
for 3 - 5 seconds.
The display changes to the Setup menu of the speedometer
functions.
Press the button
briefly.
Next display mode
To Next Page
Loading...
Need help?
General
