SERVICE WORK ON THE CHASSIS 48
B01068-10
Main work
– Remove screws 1.
– Take off connecting cap 2.
– Pull silencer cap 3 out together with the perforated pipe and glass fiber yarn fill-
ings 4 and 5.
– Clean the parts that need to be reinstalled and check for damage.
– Position the new glass fiber yarn fillings 4 and 5 on the perforated pipe.
– Mount silencer cap 3 with the perforated pipe in the main silencer.
– Mount connecting cap 2.
– Mount and tighten screws 1.
Follow-up work
– Install the main silencer. ( p. 47)
10.28Removing the fuel tank x
Danger
Fire hazard Fuel is highly flammable.
– Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
– Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Avoid contact between fuel and skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse immedi-
ately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed, con-
tact a doctor immediately. Change clothing that has come into contact with fuel. Store fuel in a suitable canister according
to regulations and keep it out of the reach of children.
Preliminary work
– Fold the seat up. ( p. 44)
B01074-10
Main work
– Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter the fuel line. Dirt in the fuel line
clogs the injection valve.
– Disconnect the plug-in connection of the fuel line.
– Mount wash cap set 1.
Wash cap set (81212016000)
B01075-10
– Remove the tube from the fuel tank breather.
– Remove screws 2 on both sides.
– Remove screw 3.
To Next Page
Loading...
Need help?
General
