B1700·B2100·B2400
WSM,11770
B177FG06
B130F060
G
GENERAL
Changing Transmission Oil
A
CAUTION
..
Be
sure
to
stop
the
engine checking and
changing
the
transmission oil.
1.
Place
an
oil pan underneath the transmission
case.
2.
Remove
the drain plugs
(1)
at
the bottom
of
the transmission
case.
3.
Drain the transmission oil.
4.
After
draining, screw in the
four
drain plugs.
S.
Fill new oil from
filling
port
after removing the
filling
plug
(2)
up
to
the upper notch on the dipstick.
6.
After
running the engine
for
a
few
minutes, stop
it
and check
the oil level again,
if
low, add oil prescribed level.
II
IMPORTANT
•
Use
only multi-grade transmission oil.
Use
of
other oils may
damage the transmission or hydraulic system.
Refer
to
"LUBRICANTS
AND FLUID"
(See
page
G-8).
lID
Never
work
the
tractor
immediately
after
changing
the
transmission oil. Keeping the engine
at
medium speed
for
a
few
minutes
to
prevents damage
to
the transmission.
lID
Do
not
mix
different
blands oil together.
122
HSTtype 3.17 U.S.gals
Transmission oil
2.6Imp.gals
capacity
ManuaI
tra
nsm
ission
112
type
2.90 U.S.gals
2.4Imp.gals
[AI Oil level acceptable within this range.
(1) Drain Plug
(3)
Dipstick
(2) Filling Plug
Cleaning Transmission Oil Strainer
(HST
type)
Since
the fine filings in the oil could impair the component
parts
of
hydraulic
system
which
is
precision
built
to
withstand
high pressure,
the
suction line end
is
provided
with
an oil
strainer. When changing the transmission fluid, disassemble
and rinse the strainer
with
kerosene
to
completely clean
off
filings.
For
reassembly,
be
careful
not
to
damage the parts.
(1) Strainer
G-13
To Next Page
Loading...
Need help?
General
