ASSEMBLY INSTRUCTIONS6
BInstalling the Lever Grip
Install the lever grips onto the control levers. See the
figure.
A Apply rubber-bonding adhesive to the lever before
installing the lever grips to permanently secure them.
BAttaching the ROPS
Remove the ROPS accessories from the crate and mount
on the body as shown in the figure below. For details of
the mounting procedure, see the ROPS assembly
instructions, and assemble correctly.
BAttaching the 3-Point Hitch Assembly
1. Attach the top link (1) and top link holder (3) to the top
link bracket (2) with the joint pin and set pin.
Set the top link (1) to the top link holder (3).
A The upper hole on the top link bracket (2) is normally
used for mounting.
2. Insert the collar (8) (3-point hitch) onto the left and right
of the 3-point hitch shaft (5).
3. Insert the lower link (4) onto the 3-point hitch shaft (5).
4. Attach the lift rod (6) to the lift arm (7).
5. Grease all screws and rotating parts of the 3-point
hitch until movement is smooth.
(1) Orange 83
(2) Yellow 63
(3) Lever grip (main gear shift)
(4) Orange 63
(5) Black 63
To Next Page
Loading...
Need help?
General
