G-4
GL6000, GL7000, GL9000, GL11000, WSM
G GENERAL
2. PRECAUTION
• During disassembly, carefully arrange removed parts in a clean
area to prevent confusion later. Screws, bolts and nuts should be
replaced in their original position to prevent reassembly errors.
• When special tools are required, use KUBOTA genuine special
tools. Special tools which are not frequently used should be
made according to the drawings provided.
• Before disassembling or servicing live wires, make sure to
always disconnect the grounding cable from the battery first.
• Remove oil and dirt from parts before measuring.
• Use only KUBOTA genuine parts for parts replacement to
maintain engine performance and to ensure safety.
• Gaskets and O-rings must be replaced during reassembly. Apply
grease to new O-rings or oil seals before assembling.
• When reassembling external or internal snap rings, position them
so that the sharp edge faces against the direction from which
force is applied.
• Be sure to perform run-in the serviced or reassembled engine.
Do not attempt to give heavy load at once, or serious damage
may result to the engine.
W10109040
• Before checking any generator or engine electrical component,
be sure to check that all terminals and connectors are tight.
• After the individual component inspection, also inspect the wire
leads for continuity; that might be the cause of the problem.
• The rotor and stator must be protected when disassembling and
reassembling.
If they are damaged, no power can be generated.
• To maintain the generator's performance and ensure safety, use
only KUBOTA genuine parts for replacement.
• Use extreme caution when working on electrical components.
Electrical shocks cause injury or death.
W10262580
(1) Grease
(2) Force
(3) Place the Sharp Edge against the
Direction of Force
(A) External Snap Ring
(B) Internal Snap Ring
To Next Page
Loading...
Need help?
General
